Alinco DR-135 Manuel d'instructions télécharger pdf (Page 4)

“

2. Configuring the Transceiver

as a Channel-Indication-Mode Unit

You can set the transceiver in the Channel Indication mode either by:

•

Setting the pad (BP4) on the printed circuit board of the transceiver

(see “2.1 Setting Up the Transceiver with the Pad BP4”);

•

Using the DR-135 Channel Data Editor

(see “2.2 Setting Up the

Transceiver with the Data Editor”).

The CH Data Editor is useful when you want to set up two or more transceivers.

When the transceiver is in the Channel Indication mode, the LCD will look like

the following:

When the Channel contains data:

Note: • The following parameters can be configured with the CH Data Editor:



Enabling/Disabling the SCAN start when the channel is to be

skipped.



Enabling/Disabling power change



Enabling/Disabling the key-lock



Enabling/Disabling MONI key



Enabling/Disabling CTCSS/DCS key



Enabling/Disabling Tone Burst output

• When the above operations are enabled and set, the setting contents

are displayed.

1 2 3 4 5 6 7 8 9 ... 19 20

Pas de commentaire

Alinco DR-135 Manuel d'instructions Page 4