Alinco DR-135 Manuel d'instructions télécharger pdf (Page 14)

“

Changing the Editor option data for Trunking.

Set followings by

key in main menu.

SQL No:

Selects the initial setting value for the squelch level.

TX POWER:

Select the output power.

APO:

Turn the auto-power-off feature on or off.

LAMP Mode:

Set the lighting mode (High or Low).

3.7 Writing the Data in the Transceiver

When you complete editing, store the new data in the transceiver memory.

Caution: • Make sure the COM port (Dsub connector) on the PC is connected to

the DATA terminal on the radio with the interface cable (ERW-4 or

ERW-4C). If not, turn off the computer and transceiver before

connecting the cable.

To write the dala in the transceiver:

On the main menu, press the

key. A window will open on the lower-

right of the screen.

Make sure the “Write CH Data (W)” option is highlighted in the window.

Press the

Enter

key to open the “Wiring the channel data into radio”

window.

Press the space bar. Another message may appear in the window,

however you can ignore it, and press the space bar again.

Turn the transceiver on.

Press the

CALL

key while holding down the

FUNC

key.

“

CLONE

”

is displayed on the display.

Press the space bar to start transferring the data. The message window

will open, telling you the transfer operation is completed successfully.

Press the

Enter

key to close the window.

Turn the transceiver off to cancel Clone mode.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

Commentaires sur ces manuels

Pas de commentaire

Alinco DR-135 Manuel d'instructions Page 14

Commentaires sur ces manuels