Alinco DR-135 Manuel d'instructions télécharger pdf (Page 17)

“

Appendix

．

A.1 Automatic Numbering Identification (ANI)

This feature allows the transceiver to automatically send the programmed

DTMF codes (up to 16 digits) just after the

key is pressed and/or

released so that the base station can identify the unit.

Two auto dialer memories, Nos. 8 and 9, are reserved for the ANI transmission.

You can enable or disable the ANI function by using the Channel Data Editor

software.

• When memory No. 8 contains DTMF codes, the transceiver sends the codes

just after the

key is pressed.

• When memory No. 9 contains DTMF codes, the transceiver sends the codes

just after the

key is released.

• When both Nos. 8 and 9 contains DTMF codes, the transceiver sends the

codes immediately after the

key is pressed and released.

• When memory Nos. 8 and 9 are empty, the transceiver does not output any

DTMF code when the

key is pressed or released.

Examples are given in the table below.

DTMF codes in dialer memories DTMF codes to be sent

No. 8 No. 9

Just after

is pressed

Just after

is released

----

8888 - 8888 -

- 9999 - 9999

8888 9999 8888 9999

A.2 Priority Watch (PRI)

Priority Watch monitors a channel different from the indicated frequency.

Every 5 seconds, the transceiver switches from the indicated frequency to the

priority channel.

If a signal is received on the priority channel, the reception time is extended to

2 seconds.

To stay in Priority channel, push

key when Priority channel is on.

1 2 ... 12 13 14 15 16 17 18 19 20

Pas de commentaire

Alinco DR-135 Manuel d'instructions Page 17